Modules & Sensors
Showing 121–140 of 156 results
-
-
-
GSM - GPRS Modules, Modules
SIM900A GSM GPRS Module with RS232 Interface and SMA Antenna
- Dual-Band GSM/GPRS 900/ 1800 MHz
- RS232 interface for direct communication with computer or MCU kit.
- FT232 USB driver.
- Power controlled using 29302WU IC.
- ESD Compliance.
- Enable with MIC and SPeaker socket.
- With slid in SIM card tray.
- With Stub antenna and SMA connector.
- It can directly interface to Raspberry Pi and Beagle Bone
- Input Voltage: 12V DC.
- High quality PCB FR4 Grade with FPT Certified.
SKU: n/a -
Modules & Sensors, Relay, Relays
SmartElex Battle Relay
Details:-
- Switching Voltage: 125VAC@10A; 240VAC@7A
- Trigger Voltage: 5VDC
- Relay resistance: 100 mΩ max
- 4.8V to 5.2V operating voltage
- 30mA typical draw from receiver
- Powerful auxiliary weapons control in RC combat.
- Glow plugs control in RC nitro vehicles.
SKU: n/a -
IR & PIR Sensors, Modules & Sensors, Sensors
SmartElex RLS-06 Analog & Digital Line Sensor Array
-14%
IR & PIR Sensors, Modules & Sensors, SensorsSmartElex RLS-06 Analog & Digital Line Sensor Array
- Operating voltage: 4.5V to 5.0 V
- Output format: 6 Analog and Digital voltages.
- Optimal sensing distance: 0.125″ (3 mm).
- Potentiometer to adjust the sensitivity of the individual sensors.
- The module is a convenient carrier for six IR emitter and receiver pairs evenly paced.
- Great useful in building fast line following and grid navigating robots
- Comes with easy to use digital outputs that can be connected directly to microcontrollers
SKU: n/a -
Sensors, Sound & Vibration Sensors
Sound Detection Sensor Module Red/Blue for Arduino/RPi/Other Microcontrollers
-59%
Sensors, Sound & Vibration SensorsSound Detection Sensor Module Red/Blue for Arduino/RPi/Other Microcontrollers
Details:-
- Main chip: LM393, Electret condenser microphone
- Working voltage: DC 3.3-5V
- Induction distance is 0.5M
- Signal output Indication
- Single channel signal output
- The output effective signal is low level.
SKU: n/a -
Sensors, Sound & Vibration Sensors
SW-420 Vibration Sensor Module
Details:-
- Using SW-420 normally closed type vibration sensor
- Comparator output, clean signal, good waveform, strong driving ability, >15mA
- Operating voltage 3.3V ~ 5V
- Output format: digital switching output (0 and 1)
- Using a wide voltage LM393 comparator
- With bolt holes for easy installation
SKU: n/a -
Light, Color & Line Sensors, Modules & Sensors, Sensors
TCS3200/TCS230 Color Sensor Module
Details:-
- Operating Voltage: 3V-5V
- High-resolution conversion of light intensity to frequency.
- Chip pins all has drawn for standard 100.
- Put the needle (2.54 mm).
- Mil-convenient for bitmap board.
- Programmable color and full-scale output frequency.
- Communicate directly with a microcontroller.
- Low-profile surface mount package.
SKU: n/a -
Audio Modules, Modules
TDA2030A Audio Power Amplifier Module
Details:-
- Operating voltage: 6 to 12V DC
- Onboard TDA2030A Audio amplifier IC
- Mono channel 18W Power amplifier circuit design
- Onboard horn socket
- 10 k adjustable resistance to adjust the volume of the amplification
- Onboard power indicator light
- Chip has lead to the main pin, can directly input the audio signal
SKU: n/a -
Modules & Sensors, Sensors, Temp, Humidity & Gas Sensors
Thermistor Temperature Sensor NTC100K
Details:-
- Temperature range of use: −40°C to 270°C.
- Dissipation power factor: ≥5 mW/℃ (static in the air).
- 100k Ohm NTC Thermistor.
- NTC Thin Film Thermistor Cable.
- Max power rating: 45 mW
- The hot time constant: ≤7 s(in the air)
SKU: n/a -
Modules, Relays
Timer Relay DC 6-30V 1-Channel Power Relay Module with Adjustable Timing Cycle
Details:-
- Operating voltage: 6-30V
- Time interval:0.1 s (minimum) ~ 999 min (maximum) continuously adjustable.
- Trigger Signal Source: High-Level Trigger (3.0 V-24 V)
- Output Capacity: can control no more than DC 30V 5A AC or 220 V devices 5A
- Optocoupler Isolation.
SKU: n/a -
BMS, Modules, Power Management Modules
TP4056 (Mini USB with Current Protection) 1A Li-ion Lithium Battery Charging Module
-26%
BMS, Modules, Power Management ModulesTP4056 (Mini USB with Current Protection) 1A Li-ion Lithium Battery Charging Module
- Input voltage : 4.5V ~ 5.5V.
- Input Interface: Micro USB port.
- Charging method: linear charge.
- A full charge voltage: 4.2V.
- Power: 4.2 w.
- Charging accuracy: 1.5%.
- Operating Temperature: -10 to +85ºC
- Charging indicator: LED indicators for charging and full charging.
SKU: n/a
![3v-3.7V Round COB led Light [ Color - Cool White ]-Smartiphi-Main](https://smartiphi.com/wp-content/uploads/2022/10/3v-3.7V-Round-COB-led-Light-Color-Cool-White-Smartiphi-Main-300x300.jpg)
